Fx Series top entry robots represent the ideal solution for particularly fast production cycles.
Thanks to their powerful motors, perfectly balanced with the moving masses, it is possible to obtain extremely short extraction times, inferior to one second, and very accurate repeatability. A robot which can satisfy the most various requirements of a demanding customer: open mould time (as typically required in the packaging sector) is reduced, and programming of special palletization, operations beside the IMM can be easily done.
Fx Series is particularly suitable for food packaging systems, IML and whenever a very short cycle time (starting from 0.71 seconds) and precise handling is required. All axes use high quality double prismatic bearing guide with special bearings for reduced maintenance and smooth operation all helping to achieve precision positioning to 0.1mm. Moreover, the vertical arm composed with a telescopic system allows to reduce the total height of the robot thus increasing movement speed.
Our STEC 510 can operate in two different ways, based on the customer’s needs: operational modes programming (preinstalled operations), and free programming, thus guaranteeing our customers the widest grade of freedom. The collision detector detects forthcoming collision with other objects and immediately stops the robot, while the vibration control system controls vibrations on the vertical axis for the optimal operation of the unloader, thus permitting an increase of smooth movements at high speeds and an increased stability at extraction time.
Thanks to our Eco mode, you will be able to save up to the 25% of electricity consumption in case stand-by times exceed the set ones, with the temporary stop of the servo motor and the turning off of the pendant background light. The automatic interruption of air supply to the vacuum generator allows a huge air consumption saving from the product collection with suction cup to its deposit on the conveyor. And there is more: speed and acceleration of the robot are automatically adjusted by conforming the operation cycle to the moulding time ensuring energy saving and noise and wear reduction.
Fx-H Series top entry robots are the ideal solution when space in the moulding room is an issue. In fact, the crosswise axis on this series is parallel to the injection axis; therefore, the release of the products does not happen on the side of the IMM but at the end of it, saving thus space which would normally be needed by a traditional 3-axis robot. This series features the same characteristics of the Fx Series with one main difference: the crosswise axis is usually longer (3500 – 5500 mm).
|Product||Range IMM||Traverse(mm)||Crosswise(mm)||Vertical (mm)|